25.04.2012 led 47w - 66- 1610 0 1 of 2 led 47w - 66- 1 6 10 0 technical data high power led array, 16 high power chips in ga n led 47w - 66- 16100 is a wide viewing and extremely high output power illuminator assembled with a total of 16 high power ingan blue color diode chips, mounted on a metal stem to - 66 a nd covered with silicone resin. these devices are designed for high current operation with proper heat sinking to improver thermal conductive efficiency. specifications (unit: mm) ? structure: ingan, 16 x 1w h igh power chips ? peak wavelength: whit e color ? optical output power: 80 lm ? package: to - 66 stem ? lens: silicone resin absolute maximum ratings (t a =25c) item symbol value unit power dissipation p d 28 w forward current i f 2 a pulse forward current * 1 i f p 3 a reverse voltage v r 2 0 v operating temperature t opr - 30 ? +80 c storage temperature t stg - 30 ? +110 c soldering temperature * 2 t sol 240 c * 1 duty = 1%, pulse width = 1 s * 2 must be completed within 3 seconds at 260c electro - optical characteristics item symbol condition min. typ. max. unit peak wavelength p i f = 600 ma - * - nm half width ? i f = 400 ma - - - nm total radiated power p o m w radiant intensity i e mw/sr brightness i v cd luminous flux v i f = 1.2 a - 80 - lm forward voltage v f i f = 1.2 a - 13.0 - v reverse voltage v r v viewing half angle 1/2 i f = 400 ma - 55 - deg. * x: 3.250.25e - 01, y: 3.250.25e -01 heat sink is required , to keep the led at 60 c. note: the above specifications are for reference purpose only and subject ed to change without prior notice.
25.04.2012 led 47w - 66- 1610 0 2 of 2 precaution for use 1. cautions ? this high power led must be cooled! ? do not look directly into the emitting area of the led during operation! 2. soldering conditions ? do not apply any stress to the lead particularly when h eat. ? after soldering the leds should be protected from mechanical shock or vibration until the leds return to room temperature. ? when it is necessary to clamp the leds to prevent soldering failure, it is important to minimize the mechanical stress on the le ds. 3. static electricity ? the leds are very sensitive to static electricity and surge voltage. so it is recommended that a wrist band and/or an anti - electrostatic glove be used when handling the leds. ? all devices, equipment and machinery must be grounded pr operly. it is recommended that precautions should be taken against surge voltage to the equipment that mounts the leds. 4. heat generation ? thermal design of the end product is of paramount importance. please consider the heat generation of the led when makin g the system design. the coefficient of temperature increase per input electric power is affected by the thermal resistance of the circuit board and density of led placement on the board, as well as other components. it is necessary to avoid intense heat g eneration and operate within the maximum ratings given in the specification. ? the operating current should be decided after considering the ambient maximum temperature of leds. 5. storage ? the leds should be stored at 30c or less and 60%rh or less after being shipped and the storage life limits are 3 months. if the leds are stored for 3 months or more, they can be stored for a year in a sealed container with nitrogen atmosphere and moisture absorbent material. ? please avoid rapid transitions in ambient temperature, especially in high humidity environments where condensation can occur.
|
